Maintenance Guide

Scooter Maintenance

If there are stains on the frame, please use a wrung out damp cloth to clean. If there are scratches on plastic parts, please use sandpaper or other abrasive materials to polish them.
Please ride with dual drive as more as possible to protect the rear controller, especially when go uphills.
Do not ride a scooter in heavy rain, or directly clean the scooter with ahigh-pressure water pump gun to prevent damage to the switch and display. Water ingress will make the battery short circuit, which is not covered by the warranty.
During the cleaning process, please turn off the scooter, unplug the charging cable and close the rubber of the charging ports to avoid electric shock or other hazards.
When not using the scooter, please place it in a dry, cool room. Do not leave it outdoors or in the trunk of a car for a long time. Excessive heat and cold will accelerate tire aging and damage the service life of the scooter and battery pack.
Please use mineral brake fluid for brake fluid.
In general, the pads need to be replaced after 600km to ensure the comfort and safety of braking. (depends on daily usage habits).
Please use bearing grease (lithium-based grease) for anti-oxidation of screws, shock absorbers, and reduce mechanical wear.
10-inch tires are inflatedwith air pressure of 310kpa, and 11-inch tires are inflated with air pressure of 350kpa.

Battery Maintenance

Due to different battery production batches, there may be differences in the color, pattern(such as wiring, interface and label) of the outer packaging . Please refer to the actual product. The performance and method of use will generally not change. Please rest assured.

Use original battery packs, use other brands battery may cause failure or bring safety issues.
Use original power adapter to avoid potential damage or fire, Charging current ≤5A.
Full Charge the battery for the first time once receive( until the lights of chargers turn green).
Do not heat the battery or near the fire source.
Do not touch the charging ports and keep it away from metal objects to prevent short circuit.
Do not dismantle or puncture the casing which may result in battery damage or even injuries.
Do not put the battery in a damp place or in water, and water ingress is out of warranty.
Keep the battery away from high-temperature heat sources and avoid charging in direct sunlight.
Charge it once a month if you do not use it for a long time.
Always charge before exhausting the battery to prolong the battery's lifespan, the 48V models are charged before the voltmeter drops to 42V, the 52v models are charged before the voltmeter drops to 45V, and the 60v models are charged before the voltmeter drops to 52V.
Turn on scooter first to consume the remaining power in the electric scooter to prevent the motor from burning the connector after unplugging the old battery.
Battery charging temperature is 0℃-40℃, discharging temperature is -20℃-40℃.
The battery can store electricity normally and discharge to the maximum at 25℃. When the temperature drops to 10℃, the battery's stored power will be reduced by 20%. Below0℃, the stored power will be reduced by 30% or more, which is normal.
Mishandling of used batteries may do tremendous harm to the environment. To protect natural environment, please follow local regulations to properly dispose used batteries.

Charge Your Scooter

Cautions

Can only use the original matching chargers for charging,Charging current ≤5A.
Red when charging, and green when fully charged. The two chargers may not turn green at the same time, there is usually a little time difference.
Full Charge the battery for the first time once receive( until the lights of chargers turn green).
Do not touch the charging ports and please keep it away from metal objects to prevent short circuit.
Do not reverse or short-circult the negative.
Can use 2 chargers to charge at the same time to shorten the charging time.
Always charge before exhausting the battery to prolong the battery's lifespan.
Battery charging temperature is 0℃-40℃, discharging temperature is -20℃-40℃.
Charge it once a month if you do not use it for a long time to protect the battery.

Steps

Open the rubber flaps
Plug the power adapter into the charging ports
When charging is completed, put back the rubber flap

Use And Operation

Preparation Before Riding

Push the red rodup to a suitable position.
Check if all the screws and frame are fixed firmly before every riding.
Wear helmets, gloves and knee/elbow pads before ridingto keep safe.

Safety During Riding

Step on the deck with one foot and kick with another on the ground, then pull the throttle to speed up. If the scooter is with a seat, please sit on the seat first.
Do not yank the accelerator to start, please gently pull the accelerator to start the scooter to prevent instant acceleration and loss of balance.
Lean your body right or left slightly when turning the steering handle bar steadily to right or left.
Please keep balance all the time during riding, do not jump off before the scooter is fully stopped.
Release the accelerator and pull brake level softly to stop the scooter. The hydraulic/disc brake system and electric brake work together to ensure excellent brake performance.
Do not ride in rain, frozen terrain.
Do not ride in vehicle lane/free way.
Do not carry any passengers.
Do not press throttle when going downhills.
Do not leave your hands off the handlebar while riding.
Do not touch the brake disc and motor after riding, beware of burns.

Legal Statement

Riding the electric scooter may cause hazardous consequences even if you obey all the safety instructions.
We assume no responsibility for any claim, liability or loss incurred by customers’ violation of clauses in this user manual.
We are not liable for any incidental damages or consequential damages due direct or indirect use of this product.
The rider by himself/herself shall undertake his/her responsibility for any unpredictable or inevitable risk during riding.

RIDE AT YOUR OWN RISK.